Sat, Nov 23, 1:04 PM CST

Renderosity Forums / Bryce

All Forums

Welcome to the Bryce Forum

Forum Moderators: TheBryster

Bryce F.A.Q (Last Updated: 2024 Nov 21 4:12 am)

[Gallery]     [Tutorials]

THE PLACE FOR ALL THINGS BRYCE - GOT A PROBLEM? YOU'VE COME TO THE RIGHT PLACE

Subject: faq? p4 into bryce 3 texture question

taerin opened this issue on Oct 21, 2000 · 1 posts
Back to Forum Print
taerin ( ) posted Sat, 21 October 2000 at 9:46 PM · edited Fri, 11 October 2024 at 9:19 AM

Hey all, this might be a frequently asked question, but I haven't found it anywhere... Is there a way to get a figure from P4 into Bryce 3 with all the textures intact? The way I've been doing it so far is to export as an obj, and then once I bring it into Bryce, subselect the parts, rename them and retexure them. However, with the one I'm working on now, there are so many parts that it will take forever to go through that sequence. Is this possible when going into Bryce 3 rather than 4? Thanks in advance, - taerin

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.