OK, I tried to work on about everything that ICM mentioned. :^) I lopped off the part of the handle nearest the head and tried to remodel it to as close as my reference hammer as I could get. I'm not sure how I did it exactly, but look at the example sticking up out of the floor in this pic. It goes from a cylinder and slopes in on four sides and becomes a cube. All in a single mesh. It took a while, and there was a lot of point editing, but I think it looks a lot better. Thanks for the advice ICM, I even put a wedge in there, but my reference has a black plastic plug in the hole, so I'm not sure of the accuracy there. :^) John

This is not my "second childhood". I'm not finished with the first one yet.

Time flies like an arrow; fruit flies like a banana.

"I'd like to die peacefully in my sleep like my grandfather....not screaming in terror like the passengers on his bus." - Jack Handy