Attached Link: Flying Rondell (Challenge) - WIP #1

Hi, today i put my attention to the engine-block and here it is. As the whole Model it it Bryce-Only-Modeling. Perhaps it needs some little "finetuning" Thanks for looking and comments Sascha aka djblueprint (My first Posting of the Rondel WIP you can reach through the attached link)

That's one cool looking engine. Nice modeling, I'm impressed. One question, where does the fuel go in and where does the exhaus go?

keep up the good work.

Message edited on: 03/12/2005 15:09

lahst of the v-18's, ey?..;)

I wish I'd said that.. The Staircase Wit

anahl nathrak uth vas betude doth yel dyenvey..;)

Awesome! And pure Bryce too. That's 18 in the eye for Pakled...(whistles and strolls off into the distance...followed discretly by a comfy chair)

Available on Amazon for the Kindle E-Reader

All the Woes of a World by Jonathan Icknield aka The Bryster

And in my final hours - I would cling rather to the tattooed hand of kindness - than the unblemished hand of hate...

? sorry, thought 9 cylinders in a 'v' shape each side was a v-18, but then I drive an in-line 4 cylinder..;)

Message edited on: 03/12/2005 19:00

I wish I'd said that.. The Staircase Wit

anahl nathrak uth vas betude doth yel dyenvey..;)

Attached Link: http://www.renderosity.com/viewed.ez?galleryid=771748&

and as for that comfy chair..;)

I wish I'd said that.. The Staircase Wit

anahl nathrak uth vas betude doth yel dyenvey..;)

very nice modelling well done

Experience is no substitute for blind faith.

http://avalon2000.livejournal.com/ - My Art Blog

http://jeferies.jalbum.net/Richard%20Jeferies%20Future%20Perfect/