The spot light parameters seem to be not working... both in document window and in a Render. Distance start, distance end, and angle start dont seem to be working. Angle start is supposed to adjust the amount of diffusion of the angle end... now the settings seems to be doing nothing at all. Same goes for the Distance settings. Distance End set at zero means the light is infinite... if it has any positive parameter at all then that should be the distance of how far the light travels... Again in P6 this is not working. Distance Start is a little bit tougher to test without being able to adjust distance end. ------------------------------ I also set up some reflections nodes and set the rendering for raytracing and I did not get a single reflection in my rendering. ------------------------------ The program does not do well after it has been open for awhile... I know there are speculations of memory leaks... I am not sure... I just know that after a while the program wont even render a tiny little square. ---------------------------- I hate to say it but my first impressions are not that good, Not much better than when CL released P5.... I hope that I am wrong and I am just missing something. Christian