Hi, For awhile now I've had a bit of a problem with my cameras while I'm constructing things in Carrara. While I'm modeling I tend to twist and turn my view of an object to see it from all possible angles. After awhile my camera view starts to look kinda weird, I end up with distorted twisted, almost fish-eye, kind of views and it's always a pain to get the view back to normal. When it happens with camera1 (or 2..etc), its not so bad since I can just select the camera and set it straight. But when I mess up the director's camera, it's harder to "un-twist" the camera view. Any suggestions on how to avoid this? Oh and while I'm at it. When in the spline modeling room, every time I go to the grid dialogue box and check or uncheck the snap to button, an error message pops up. I click OK, it disappears and all is well, but it is a bit of a nuisance. Anybody else experience this? Thanks, H&B