Forum: Poser - OFFICIAL

Subject: A question about curtain.

Aioria opened this issue on Aug 16, 2005 · 6 posts

Aioria posted Tue, 16 August 2005 at 10:23 AM

It show in the picture is the parameter of my made curtain. When I run the simulation.The curtain did not rises below ripples.How to resolve this problem? Thanks.

xantor posted Tue, 16 August 2005 at 11:39 AM

Attached Link: http://www.poserfashion.net/curtain1.htm

There is a very good tutorial about making curtains work at the link.

xantor posted Wed, 17 August 2005 at 5:43 AM

If that was the tutorial that you were following, you might not have set up the constrained groups, they are needed for the curtain to be the correct shape.

Aioria posted Wed, 17 August 2005 at 7:32 PM

Thanks. I have made the Curtain.

Aioria posted Wed, 17 August 2005 at 9:42 PM

After I import the rail.obj,I need go to the setup room.Why do that?

xantor posted Thu, 18 August 2005 at 8:55 AM

You need to make the rail part into a figure so that it will work in the cloth room.