Forum: Poser - OFFICIAL

Subject: It is a question of creating bone.

Aioria opened this issue on Nov 09, 2005 · 7 posts

Aioria posted Wed, 09 November 2005 at 6:01 AM

After I imported a cylinder in the Poser I got into the Setup Room,then I used the P4 bikini bottom to get into the Cloth Room.There is a promote likes that:This figure contains polygons which are not grouped to be long to 2 bone.Are you sure you want to leave the Setup Room? By the way,why the font size of my Poser's promote is too small,how can I adjust it?

xantor posted Wed, 09 November 2005 at 2:26 PM

You need to check that all the polygons are attached to bones, sometimes only one small hard to see polygon is not attached and brings up this error.

Aioria posted Wed, 09 November 2005 at 6:39 PM

How to check that all the polygons? why the font size of my Poser's promote is too small?

xantor posted Wed, 09 November 2005 at 9:01 PM

If you look at the object in wireframe mode, it is usually easier to see the stray polygons.

Aioria posted Thu, 10 November 2005 at 1:55 AM

The image is used in wireframe mode.But the promote is all the same.

xantor posted Thu, 10 November 2005 at 1:23 PM

No, you switch on the wireframe mode and then use the grouping tool to see which polygons are not in a group.

Aioria posted Fri, 11 November 2005 at 7:42 PM

Thank you.I get it.