Hi all,

I did the following, and struck a slight problem :

(1) Loaded up the Apollo Max figure.
(2) Separately loaded up the DAZ D3 figure and moved him away from Apollo.
(3) With D3 still selected, I loaded up all of his body and head morphs - in turn, the new morph dials appeared (set to zero) in the parameter window (so far, so good).
(4) I then applied an injection morph (Shane by A_), and the affected morph's values were updated appropriately ...... BUT .... no change to D3 !!!

Note that injecting the morph to D3 works just fine if I do it the other way around. Also, there are no problems with loading Apollo's morphs in this scenario.

So, is this "crosstalk" ? ..... I thought this phenomenon only occurred when you have two Unimesh characters.

Can someone offer a solution please ?

thanks and regards,
Andrew