Hi there :)

i need a little help if you can...

i made out a figure and added several dials but it have a strange behaviour with only 1 dial (switching geometry), it his related to the "hip" and this behaviour happens only if i change the internal name of the "hip".

i mean: the internal and external original name of the hip part is "wall",

if & when i change its internal name from "walls" to "hip" (keeping the external one as "wall") than the switch dial has always a value of 1 (:

you can save poses and figure with different switch dial values but when Poser open them the switch dial value is always set to 1. make this sense?

i tryed to clean the cr2 either by wordpad and some utilities but not yet found a solution.

any help?

thanks in advance :)