Hi All

Forgive me if this has been covered before, I had a look and couldnt find anything.

I have convereted a few conforming clothes to dynamic through various suggestions found in this forum and when I put them on a character then do a simple pose (usually standing) then the simulation works ok and poser calculates through all the frames. When I do somthing a bit more complicated like mike sitting on a throne then the simulation tends to stop half way through. I have tried turning poser off then on and trying the simulation again but it stops at the same frame again.

 

I was just wondering if anyone had anythoughts, I am at the office at the moment so cant provide more specific details other than  my procedure below.

Pose Mike on frame 30 of 40 frames,

goto frame 1 import dynamic clothing and adust onto figure,

goto cloth room,

create simulation,

settings to 40 frames,

clothify clothing, collide against throne ground and mike, ignore head & feet collisions,

then calculate,

it usually gets to frame 24 for most of these types of poses before it stops.

 

Thx in advance

 

Scott