ericwestray opened this issue on Apr 07, 2001 ยท 5 posts
ericwestray posted Sat, 07 April 2001 at 4:18 PM
Is there a utility out there, or is there some way of transfering morph targets from one P4 character (millenium models included) to other like characters?
milamber42 posted Sat, 07 April 2001 at 4:28 PM
MorphManager. See this message. http://www.renderosity.com/messages.ez?Form.ShowMessage=266127
flamethedog posted Sat, 07 April 2001 at 4:41 PM
Set morph target dial to 1, all others to 0. Export as morph target. Load in other character that has same body part/vertice count.
Wizzard posted Sat, 07 April 2001 at 11:35 PM
Note.. the figures must use the same mesh geometry... i'e' newmalenudeHi.obj etc... other wise the MT will be there .. but not do anything... ye can't swap twixt ..say.. a P3 figure and the MilliMan Now magnets are another story.. those I think ye can swap.. though the MilliMan once again might be a bit difficult. Cheers poste scriptum, MOrphmanager should be in freestuff under utilities..
Gem_719 posted Sun, 08 April 2001 at 11:18 AM
Attached Link: http://www.3d-cc.com/3dhome.asp
Get MorphManager here: http://www.3d-cc.com/3dhome.asp It's on the home page under the 4/7/01 heading.