Lighthorse opened this issue on Sep 27, 2008 · 3 posts
Lighthorse posted Sat, 27 September 2008 at 9:27 PM
OK
I will try to make this simple
I have a product Picture Here
What I need to figure out is How do I get the Ailerons, Flaps,
Elevator and Rudder to move properly with a set limit. and
how to set up the actual hing point for the rotation.
I have all Parts loaded separately in Daz and Poser.
I do not see any were how to set those up and save it as a cr2
file that is ready to use for daz and poser.
Lighthorse
FalconArts.Com
