Hi again, all,

This is related to a previous post I made about dynamic cloth. I am still learning the ropes here and thank you for your patience. I just wanted to get your advice about one scenario:

I load up a scene, Vic 4.2, and a cloth. I start new simulation, and in the first run, set collide parts to the entire Vic figure (I know this might not be advisable, but I wasn't sure about all the body parts I should set the collisions to, as the cloth is large). I run Calculate Simulation and for the first few poses the drapery works great.

However, I do another pose, which is not radically different from the previous ones, and the drapery is totally messed up. I try zeroing the figure, starting a new simulation, and I get the same result. I delete the drapery, zero the figure again, start a new simulation, set the collision parts to the ones I think are pertinent, same result. I do the whole operation again with the full Vic body parts colliding, exactly same result. I close Poser (7 in this case), and restart, same results again.

Any idea what is happening?

Thanks!