I used a staff from a staff set at daz which used DSON to put it into poser.  to my suprise the grouping tool worked and i was able to cut off the bit I wanted and discard the rest of it.

I need to make it wider at the bottom than the top I think.  But there is no taper dial.  I then decided to try the morphing brush to make it look a bit more didgeridoo like. However the morphing brush only seemed to work on the rings at the top and the bottom of the object.

So then I exported the .obj and reimported this, thinking it would now work, but I still can't use the morping brush except on the very top or the very bottom of the cylinder.

Any ideas how i can make this thing into a didgeridoo?

MY ONLINE COMIC IS NOW LIVE

I aim to update it about once a month.  Oh, and it's free!