So I took A3, and exported and OBJ from DS, modified in Hex and now want to create a distributable morph from it.

I have run into dead-ends in DS, so I am looking if it is possible in Poser 9?

So I've got an OBJ of A3 with my morph, and was reading tutorials on making Morph Targets...but so far I get nothing but Target Geometry has wrong number of vertices".  All I did in Hex was to rearrange vertices.  No deletes, welds or the like....moved and smoothed only.

That being said, most tut's show using like just the "head", and in this case, I have the whole figure as an OBJ.

Is it possible?  Any tips, help or point me in the right direction?

Thanks!