I'm learning to make morphs and load them into a figure.  Today I finished a morph that fixes both armpits and when I got done I realized that I should have made the morph separate for each armpit...left and right instead of one for both.

I used PML to create the morph.  In the figure drop down in Poser I have Body and various figure parts.  In Body the morph is there but if I click on it there is no Split Morph option.

In the rCollar, chest and rShldr the morph is there too and if I click on the morph when these body parts are selected then I can click on the morph and I get a split morph option.

I tried this and it made left and right morphs for these body parts.  The problem is that you have to select the body part (ie- rCollar), dial in 1.00 for the morph then go to another body part (ie-chest) and dial in the morph, etc.  That is unacceptable.

Why don't I get a split morph option under Body?   This was a tedious morph to make and I don't look forward to redoing the whole procedure again.