I'm off in an area of Poser that I've never looked at before, and I'm getting a bit lost.

I have two pairs of bowls: Bowls1Left and Bowls1Right, and the same with a 2.

And I've been mucking about with Parameter Dependencies.

Right now, as I modify zRotate on Bowls1Right, zRotate on Bowls1Left smoothly and simultaneously adjusts its zRotate to match. Bowls2 act *almost* the same, except that Bowls1Left does not "smoothly and simultaneously" adjust to match, but, instead, snaps into place when I release the dial.

I am at wit's end trying to figure out what is different. It was hours of reading and futzing to get where I am, ya know? So, when I had Bowls1 working and tried to replicate that with Bowls2, in truth I didn't really know exactly how I got Bowls1 working. Sigh.

Any clues? Tip? Hints? Rude suggestions?