itsrainin opened this issue on Oct 10, 2001 ยท 5 posts
itsrainin posted Wed, 10 October 2001 at 12:07 AM
anyone used network rendering? I cant seem to get it to work. The network manager in bryce picks up the proper ip's of the machines, but then it give the unreachable symbol (red circl with lightbolt) I have about 5 machines connected to the net on a cable router, anyone know how i can get network render to work??? itsrainin
mercutio posted Wed, 10 October 2001 at 8:14 PM
This may not be much help, but I have a network on a cable router and sometimes I get the red, sometimes I get the green. I can't explain it. I would love to know the answer.
Deathbringer posted Thu, 11 October 2001 at 1:53 AM
Same here, just uncheck all the boxes, recheck them and it should pick it up.
SevenOfEleven posted Fri, 12 October 2001 at 6:14 AM
Can you tell us if you get any problems with the picture after you use network rendering?
Deathbringer posted Sun, 14 October 2001 at 7:00 PM
I have never had any probs with getting or viewing the picture after network rendering something.. It normally saves it and opens paint the minute it is done rendering..