As mentioned in a earlier post i've cutted the hood the way it's a flip-front. The hardest thing on this was to find the ringt angle-point that the hood can be opened without touching the wheels too much. Means it's not possible to not touch the wheels, because otherways the hood couldn't open as much as needed. But it stives the wheels now on a really small area. Now i also have to find a good line which doesn't destroy the sideline to much for the doors. After this the door-inlays can be done. After cutting the doors the engine will become a new fuel-injection-system and cylinder-covers. And finally the whole thing had to be run trough UVMapper to assign the groups and all the materials. At end the base collor will be a grey fading to black with a appropriate reflection-map. SHARKEY