Forum: Poser - OFFICIAL


Subject: solution to bad polys in draft mode

wdupre opened this issue on Sep 10, 2002 ยท 9 posts


wdupre posted Tue, 10 September 2002 at 2:00 PM

found out how to get rid of bad polys in draft mode, not sure if anyone else has discovered this; draft render with remove back facing polys checked



wdupre posted Tue, 10 September 2002 at 2:00 PM

and with remove bad polys unchecked.



wdupre posted Tue, 10 September 2002 at 2:07 PM

oh and by the way I am thrilled with the P5 experience so far. registration was a snap. these renders(I know they're simple)maybee 30 seconds each on an athalon 800. havn't checked out everything yet but been switching between rooms and fiddleing with settings for hours and havn't freezed up the program yet.



Hiram posted Tue, 10 September 2002 at 2:08 PM

Sorry.


geep posted Tue, 10 September 2002 at 2:13 PM

Thanks for sharing that "tip" wdupre. Has anyone started a "P5 Tips & Tricks" notebook yet? ;=]

Remember ... "With Poser, all things are possible, and poseable!"


cheers,

dr geep ... :o]

edited 10/5/2019



mateo_sancarlos posted Tue, 10 September 2002 at 2:14 PM

Is there a grouping function where you can click on the bad polygon and reverse normals?


wdupre posted Tue, 10 September 2002 at 2:15 PM

yes i saw it but didnt try it yet



ronmolina posted Tue, 10 September 2002 at 3:35 PM

You can use the grouping tool to isolate it and then flip it. Ron


maclean posted Tue, 10 September 2002 at 4:00 PM

lol@hiram I had to read it twice before the penny dropped.... lmao mac