First, my sincerest apologies to all concerned.

The size of my "Scale" props is NOT correct! And here is why...

A little history ...

I first generated my (original) 12 foot Scale prop about 2 1/2 years ago because I had a need to create Poser props that were accurately scaled in real world units (i.e., feet and inches).

At that time, as some of you may already know, there were no real world scale units in Poser, only "Poser" units (whatever they were). There never has been ............ until ............ Poser 5.

Now, it would appear that I have a massive amount of egg on my face because whoever (and I am NOT pointing any fingers) created the Poser unit of measure did not use the same multiplier (or divider) that I did to correlate Poser units to real world units of linear measure.

The bottom line is that ...... it appears that I am wrong ..... and I will have to redo all my Scale props to conform to Poser5's units of measure. And, I WILL do that!

A long story short, discard (delete, throw out, can, destroy, decimate, cancel, don't use, etc., etc., etc.) any and all of the "Scale" props that I may have sent you.

I will begin again and use Poser 5's units and then repackage the whole thing for distribution.

"Rome wasn't built in a day ....."
(but it didn't take very long to burn down, did it!)

Well, back to ye ol' (electronic) drawing board.

I'm very sorry ...

I'll get back to y'all when I get things fixed, if you're still interested.

(very muffled, if any) cheers,
dr geep
;=[

Remember ... "With Poser, all things are possible, and poseable!"

cheers,

dr geep ... :o]

edited 10/5/2019