Mk. 82 "Snakeye" by CeruleanGhost

Rhino 3D • Military • posted on Sep 28, 2005

Open full image in new tab Zoom on image

Hover over top left image to zoom.
Click anywhere to exit.

Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.

Description

Mk. 82 General Purpose Bomb with a "Snakeye" tail section. This is one of my earlier models that I've just got around to rendering properly. It's not completely correct - the mounting lugs especially are very wrong - but meh. It's not textured because Rhino keeps crashing whenever I try.

Comments (10)

CeruleanGhost

1:34PM | Wed, 28 September 2005

I'll add also that the astute viewer will notice it has no fuse assembly. This is because none of my references showed one clearly enough that I felt confident in getting it correct.

)

HazyHairs

4:52PM | Wed, 28 September 2005

those are retarding fins to slow the desent of the GPB.

)

mansoa_98

5:27PM | Wed, 28 September 2005

Dont know much about bombs, but this is by far the best work i saw from you, even if untextured. I like it in every single detail.

Iconumbra

7:47PM | Wed, 28 September 2005

12 years ago I built these for a living in the Air Force. The fuse assembly consists of a booster cup that fits inside the nose then the fuse would go inside the booster cup. the fuse would be one of a couple different kinds but usually on a air retarding fin assy it would be an forward arming vain that when released from the plane a lanyard would pull out and allow the vain to spin thus arming the fuse. fuse goes boom, then the booster cup goes boom then in-turn the tritonal inside the MK-82 goes KABOOM. The model look really close. keep it up.

)