GejBox by divxkip
Close
Hover over top left image to zoom.
Click anywhere to exit.
Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.
Description
This is a piece of hardware I modeled for a new product coming out. It's actually a work in progress as I still have a few more elements to add. I like the progress so far and wanted to post my results. Total time spent modeling and texturing was about six hours. Let me know what you think.
Comments (4)
pjz99
That's a nice complicated bit of modeling :) I'd suggest a little bevel or fillet (depending on what Lightwave calls it) on some of the edges to make them look a bit less sharp e.g. the plastic inside of the RCA jacks and the gray molded shell. You might also make the texture of the gray molding a little less mottled, and turn down specular width on the metal parts.
divxkip
Much appreciated. I don't have it lit properly. As I said, work in progress. Should be ready by tomorrow. I'll take a look at your suggestions. Thanks much!
Fidelity2
Very well done. 5+.
Tammy
Nice modeling, you can tell you put allot of work into it. Good luck with the rest of it.