Ice Skates (Suggestions needed) by m25yucka

Work In Progress • (none) • posted on Jul 17, 2002

Open full image in new tab Zoom on image

Hover over top left image to zoom.
Click anywhere to exit.

Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.

Description

I am modeling some ice skates and I was wondering if anyone knows of an easire way to make the laces. what I did wsa create a spline and thread it through the areas where I will eventually have holes. I then lofted a very thin rounded rectangle along the spline. It is funky when viewed up close, however, and I am wondering if there is a better way to do this. I am using 3D Studio Max 4

Comments (2)

)

artistheat

10:16AM | Tue, 23 July 2002

I'm not a modeler,But these look great,Can't help with the laces..sorry...

Troll-69

6:30AM | Sun, 03 August 2003

I wonder if it would be posible to have a line of stitching around the top of the oe area of the boot in an effort to lend realism. The laces might be redone and put a frayed or worn look about them. These are only suggestions from someone who can not, as yet, accomplish what you have. Nice work. Regards Troll-69