Mon, Nov 18, 5:50 PM CST

Conform problem (for Exnem)

Poser (none) posted on Dec 17, 2013
Open full image in new tab Zoom on image
Close

Hover over top left image to zoom.
Click anywhere to exit.


Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.

Description


Showing conform problem with sleeves of Exnem's Enchantress where it loads properly and then shifts off center when conformed. But with same setup and same V4 any other figure such as Exnem's Warrioress conforms properly. This is the first time I have had a problem with any of Exnem's fine products, but it would be nice to get it fixed. I am surprised that this problem wasn't found in testing, except that it looks ok from the front.

Comments (2)


)

hborre

10:27PM | Tue, 17 December 2013

If I were you, I would post the problem in the forum. Someone there might have the solution.

)

drifterlee

8:52AM | Wed, 18 December 2013

You should contact the vendor. I bought the Santa suit over at RDNA and the morphs did not work. The told me they updated it and that fixed it.


0 198 0

00
Days
:
06
Hrs
:
08
Mins
:
59
Secs
Premier Release Product
DZ Viper Chain for G8M
3D Figure Assets
Top-Selling Vendor Sale Item
$18.95 USD 40% Off
$11.37 USD

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.