Car Chassis by pauljs75
Close
Hover over top left image to zoom.
Click anywhere to exit.
Members remain the original copyright holder in all their materials here at Renderosity. Use of any of their material inconsistent with the terms and conditions set forth is prohibited and is considered an infringement of the copyrights of the respective holders unless specially stated otherwise.
Description
Just something I'm working on. It's going to be the chassis for an open engine roadster. I'm not sure what kind of body I'm going to put on it, but I don't plan on doing anything typical. :)
Comments (3)
xenic101
comment censored
tallpindo
You're not thinking weight bearing yet. There has to be some sort of appendage out there for the top of the spring to go in between the lower wishbone and itself. Whether it has an upper wishbone is a matter of correct geometry and cost and weight. Then you want to look at roll center. For unequal length (bottom longer than top) the roll center is on the road surface or beneath it which is bad. This is more like a rear which once was live axle or DeDion upper tube connecting the two sides but became parallelogram. The modelling will all work out. You do very good work.
locust9
I think your off to a good start.