Exnem Demon Wings for Genesis 3 and Genesis 8 by N/A

Contains Adult Content!

Software:

Daz Studio 4

Base Figures:

Genesis 3 Female, Genesis 3 Male, Genesis 8 Female, Genesis 8 Male

Departments:

3D Models•Props•Halloween

Available Uses:

Standard License, Extended License

Demon Wings for Genesis 3 and Genesis 8 characters. Can be used with any other character, you just have to reparent the wings to your character's chest bone.

These are prop Demon Wings to use on any figure you want. They come with 45 different morphs so you can create any form and pose them any way you like.

Included are 5 different materials for Iray; Flesh, Bat, Black, Red and Purple.

--------------------------------------

System Requirements:

Daz Studio

--------------------------------------

Ownership Statement:

All of this product's content was created by Exnem

--------------------------------------

Installation Instructions:

Extract the zip-archive with your unzip program:
- Open your unzip program and press the button -Extract To-
- Select the disk and folder that contain your Poser program.
- Make sure that an option to extract full paths is selected to make sure you keep the right folder structures within your poser folder.

--------------------------------------

Usage Tips or Limitations:

To use, simply load your figure then load the wings from your Props (props/exnem/demon wings).

The prop is asmart prop so it will automatically be parented to one of your character's chest bone. However if you load a figure other than genesis 3 or 8, then you will have to reparent the wings to your character's chest bone.

You can use the "translation" or "scale" dials to adjust the initial scale and position of the wings.

Use any of the morphs in the parameter dials as you see fit.

*Note: If you use the "Smaller" morph to set the size of the wings instead of the scale dial, you will need to cut the percentage of the other morphs by the percentage you use the "smaller dial". For example, if you set the smaller morph to 0.500, then the other morphs need to be set at 0.500. If you set the smaller morph to 0.300 then the other morphs need to be set at 0.700 and so forth... Personally I recommend using the scaling dials instead but this morph is included in case you need it.