Wed, Dec 4, 1:24 PM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Dec 04 12:42 pm)

Poser Gallery - Poser Freestuff

Subject: PZ3 Problem

TheBob opened this issue on May 07, 2007 ยท 6 posts
Back to Forum Print
TheBob ( ) posted Mon, 07 May 2007 at 11:37 PM ยท edited Wed, 04 December 2024 at 3:40 AM

ok i made a character in poser 7 and i went to load it later..and poser opens and loads halfway through and then just exits

R_Hatch ( ) posted Tue, 08 May 2007 at 12:43 AM

Have you installed the latest Poser 7 service release?

TheBob ( ) posted Tue, 08 May 2007 at 9:07 AM

no i havnt its just poser 7 no patches or upgrades

TheBob ( ) posted Tue, 08 May 2007 at 10:41 AM

and the figure was victoria 4.1 if that matters

Dizzi ( ) posted Tue, 08 May 2007 at 11:57 AM

Then install SR1.1.


TheBob ( ) posted Tue, 08 May 2007 at 1:20 PM

i made one victoria 4.1 character and it loads fine..but these other two i made after that dont

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.