I figured out that a skydome setup with a certain atmosphere setting looks quite nice. However, when I save this into the library as a Scene and load it again, the atmosphere settings are gone. It would be convenient if they were saved, too.

That depends on how you 'open' the scene from the library: if you **import **it (the 2-ticks button or double-clicking) what you describe is what you'd expect. If you use the single tick it should **open **the scene as saved including atmosphere set-up.

Edit: wow, this forum software is still completely messed up: those double asterisks surround words I wanted to emphasise in bold.

Hello cspear,

That depends on how you 'open' the scene from the library

Cool. It works as you say. Thanks a lot!

can it be saved as a material preset?

kyraia: That is wonderful that you shared the atmosphere setting. That will help a lot of users here! Thank you. In fact, I'm going to start a new thread on atmospheres for everyone if you would like to join in.

cspear: Could you give a screen shot of the markdown code that didn't translate to bold, perhaps there was a glitch we didn't catch and I can bring it to the programmer's attention.

I noticed the same thing. I click on the 'B' and those asterisks show up in the preview. When I click Add Comment they are still there, no bold lettering.

I'll let the admins know guys. Thanks for the info!

Thanks for the info on this...

cspear, they also** froze **yer avatar.

kyraia, that looks like good setting for large scene. thx fr info.

To clarify the one tick vs. two ticks. One tick: replaces the scene or figure in the scene while the two ticks imports or adds the scene to the existing scene.

I hope that makes sense to everyone.

I want to make a Frozen joke about the frozen avatar comment sooooo badly.... :) *restrains self from silly jokes Where's Elsa!!!! Sven! Put that down!