Mon, Nov 25, 4:33 PM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Nov 25 12:38 pm)

Poser Gallery - Poser Freestuff

Subject: Surface material problem

nontroppo opened this issue on Apr 27, 2003 ยท 5 posts
Back to Forum Print
nontroppo ( ) posted Sun, 27 April 2003 at 12:25 PM ยท edited Mon, 25 November 2024 at 8:20 AM

I have lots of downloaded extra props and figures, some of which were meant for Poser 4 not Poser 3 (I have P3) but I have the following problem with all of them, regardless: When I apply a surface material specifically to one part of the prop, the entire prop gets that material (and bump map). I can't figure out how to apply a different material to each part (eg. walls, roof, door of a house) although these separate parts are listed in the drop-down menu and I've tried doing them one at a time. How do I apply a different material to each part?

MegaJar ( ) posted Sun, 27 April 2003 at 1:12 PM

Look in the Materials Window and make sure the "Material Changes Apply to Entire Figure" checkbox is NOT checked. If it is checked, that could be what's causing the problem.

maclean ( ) posted Sun, 27 April 2003 at 2:07 PM

Yep, there's nothing else that could cause it. mac

Little_Dragon ( ) posted Sun, 27 April 2003 at 2:54 PM

I was under the impression that one-material-per-item was one of Poser 3's limitations.


maclean ( ) posted Mon, 28 April 2003 at 2:21 PM

Oops! I never used poser 3. Went straight from poser 2 to 4. mac

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.