Fri, Jan 24, 6:03 PM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2025 Jan 24 4:20 pm)

Poser Gallery - Poser Freestuff

Subject: Web Swing Pose

f91 opened this issue on Jul 27, 2000 ยท 5 posts
Back to Forum Print
f91 ( ) posted Thu, 27 July 2000 at 4:10 PM ยท edited Sun, 28 July 2024 at 2:59 AM

file_130803.jpg

Here you go two more web swing poses I made this morning. The xyz on the web is pretty hard to control. It takes me a few minutes to get it in place. Comments always welcome. Gerry :)

f91 ( ) posted Thu, 27 July 2000 at 4:59 PM

Yeah I try to use magnet to pull the bottom on the web to create some curve but it didnt work.

Wizzard ( ) posted Fri, 28 July 2000 at 12:50 AM

Really good.. looks a lot like a 3d lift from the comics... you are going to post these ne? Thanx ) Wizzard

f91 ( ) posted Fri, 28 July 2000 at 1:33 AM

Thanks! I already send them to 3D Comic Collective & PropsGuild.

f91 ( ) posted Fri, 28 July 2000 at 1:14 PM

I have the same problem. Eveytime I open a new Pz3 or Cr2 that has more than one figure Pose will automaticly select to the conforming figure. Just make sure you select the target figure before you pose. Also set your figure "Body" x, y, zTran to "0". I found that help me easier to pose. Hope that help!

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.