i create metal bell on end of the cloth is look very good but when i create animation the bell be smeared & some of bells is disappear. what i can to do that bell behave like metal not like a fabric in animation ? sorry about my einglish is not so good

Not sure if it's just me, but I can't see your picture :o/ And I'm not quite sure what you're asking without it. Can you please repost it?

Hrm, the image doesn't appear for me either. From what's said in her message, I think what tamy's tried to do is place a bell at the end of a piece of a dynamic cloth and when she runs the simulations, the bell is also treated like it was made of fabric. I think she wants to know how to make the bell behave in a solid, rigid manner while still being involved a dynamic cloth simulation. Nuke

Try this, the bell and ribbon is one model comprising of two groups. In the Pose room select the model then go to Object/Create wind force. Set the wind to blow against the bell as shown. Vary the amplitude to make it sway. Now in the cloth room clothify the whole model. Assign the end of the ribbon to be in the choreographed group. This will prevent the model just falling to the floor. Assign the bell to the rigid decorated group. This will stop the bell from deforming. Calculate the simulation. If you do not get enough movement alter the settings of the wind.

Incidentally the bell was made from the MetaDrops talked about in an earlier thread. The ribbon is a section of the Poser 5 cloth plane.

Hope this helps.