Wed, Feb 5, 3:37 AM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2025 Feb 05 2:05 am)

Poser Gallery - Poser Freestuff

Subject: Create Inj Pose From Custom Head Morph ??

mathman opened this issue on Jan 09, 2005 ยท 3 posts
Back to Forum Print
mathman ( ) posted Sun, 09 January 2005 at 3:32 PM ยท edited Wed, 05 February 2025 at 12:46 AM

Hi all, I understand that IPB does not support custom morphs. That being the case, if I have created a custom head/face morphs (e.g. using magnets, or transferring via Morph Manager), how do I create Inj/Rem poses from it ? thanks and regards, Andrew

roxcat ( ) posted Sun, 09 January 2005 at 4:12 PM

Attached Link: http://www.renderosity.com/messages.ez?Form.ShowMessage=1803137

I just did this recently and I got a lot of help from this thread. I hope you'll find some useful information there.

Hdrider ( ) posted Sun, 09 January 2005 at 5:45 PM

Attached Link: http://home.online.no/~kjellil/Index-AllStuff.htm

Hello,

There also is a free program at this website you might want to check out. I've been using it lately to create some custom body and head INJ/REM's from the V3 New Generation figure and it works great. Only drawback is that it uses the blank channels in the Mill. figures so if they are used by another custom morph, it takes a little investigation to juggle em around.

Hope this helps.

Later...

No good deed goes unpunished ...

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.