Thu, Nov 28, 7:25 PM CST

Renderosity Forums / Poser Technical

All Forums

Welcome to the Poser Technical Forum

Forum Moderators: Staff

Poser Technical F.A.Q (Last Updated: 2024 Nov 13 12:50 am)

Welcome to the Poser Technical Forum.

Where computer nerds can Pull out their slide rules and not get laughed at. Pocket protectors are not required. ;-)

This is the place you come to ask questions and share new ideas about using the internal file structure of Poser to push the program past it's normal limits.

New users are encouraged to read the FAQ sections here and on the Poser forum before asking questions.


Checkout the Renderosity MarketPlace - Your source for digital art content!

Subject: Help! I have a conforming problem...

Gorodin opened this issue on Jul 02, 2005 · 4 posts
Back to Forum Print
Gorodin ( ) posted Sat, 02 July 2005 at 12:47 PM · edited Mon, 25 November 2024 at 4:58 AM

file_264601.jpg

I have this clothing set I created, and I think that I did most everything right. However, when I add the clothes to the figure and conform, the position is a little off, as seen in th eattached figure.

When I Zero the clothes figures from the Joint Params window, everything is great again!

Gorodin ( ) posted Sat, 02 July 2005 at 12:48 PM

file_264603.jpg

Here I have zeroed the clothes after conforming them.

Gorodin ( ) posted Sat, 02 July 2005 at 1:39 PM · edited Sat, 02 July 2005 at 1:40 PM

I think I have it fixed now.

Thanks to DominiqueB of Digital Cats Media who wrote:

"Have you tried zeroing the clothing and doing edit/memorize figure and save. See if that works for you"

It worked!

Message edited on: 07/02/2005 13:40

insomniaworks ( ) posted Mon, 04 July 2005 at 11:08 AM

I am very familiar with this problem, I have done two years research on it, lol. I have a cure for this problem once and for all. Read my instructions for V3-what ever conversion kits. I couldn't have made the promises of a near perfect fit until I overcame this problem. You can find these in the Market Place. The instructions and tutorial, although involve magnets, explains a method of getting around this problem with daz.cr2s. Many of daz .cr2s will skew the position of a .obj in a way that it will shift out of position right after conforming. Those who insist on doing it the old fashoned way will always getting noticable skewing in the fit in the feet and forearms and hands.

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.