Mon, Dec 23, 6:23 PM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Dec 23 1:20 pm)

Poser Gallery - Poser Freestuff

Subject: So , how to put a rigging info into a .pz2 file ?

alizea opened this issue on Feb 12, 2008 · 3 posts
Back to Forum Print
alizea ( ) posted Tue, 12 February 2008 at 2:38 PM · edited Sun, 29 September 2024 at 11:51 AM

As explained in my previous thread , I'm trying to make an INJ file to fit the V3 MCD to V4 in one click  - the morph appears like a dial in V3 MCD list of morphs.
It works on a static figure but it stretches once V4 posed - logical because the dress is not rigged for V4 but for V3 - as svdl was pointing .
How can I put this information into a distributable file as .pz2 - I would like to have a "one-click " solution for the final user .
I don't know where the rigging informations are in a .cr2 .
Thanks in advance !

Alice's and GND4's Tailor !
 Check my free clothing fits : www.alizea3d.com

EnglishBob ( ) posted Thu, 14 February 2008 at 5:27 AM

Attached Link: http://www.daz3d.com/i.x/tutorial/tutorial/-/?id=72

FyreSpiryt has a tutorial on making joint setting poses at DAZ - see link.

alizea ( ) posted Thu, 14 February 2008 at 6:19 AM

It looks that's what I was looking for , I'll give a closer look this evening and I'll let you know !
Thank you so much !

Alice's and GND4's Tailor !
 Check my free clothing fits : www.alizea3d.com

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.