was wondering if carrara sdk can make sliders for translate, rotate, scale?

the motion tab swims in my vision.

mebbe is possible to slave translate, rotate, scale in poser to parameter dials that will show up under parameters in rara?

thanks!

huh? somehow i switched forums while posting.

dear mod, please move this to carrara forum, thanks!

Hey @MistyLaraPrincess-- I'm now moving this thread to the Carrara Forum. Thanks!

@MLP, That is possible and some of the plug in developers engage that feature. Additional, many of the controls/parameters for figure controls are dials/sliders as in Poser. However, not all figures have parameters that are pre-built as dials - especially the older ones. Consequently Carrara doesn't do anything with those other than present you with the regular motion tab.

these few minor things trying to work out -

the motion tab is a blur on an all night carrarathon.
sliders would help. like to open a door 'easy to see' for tired eyes

need a scale preset between 30in, 30ft, and 3000ft, where can drop a native content terrain and an Aiko3. without the hours of scaling finnagling.

starting to get used to the z,y swap, but harder on the all nighter. is there something in prefs to swap z,y

wishing the vertex modeller had the basic feature from wings3d, loop edges, cut, "how many"#, connect all the fresh cuts in the loop. cut and stitch seems overly complicated in the uvmapping

b'deyh b'deyh thats all folks thanks for listening