Wed, Dec 25, 8:28 PM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Dec 23 7:38 pm)

Poser Gallery - Poser Freestuff

Subject: "man in diving suit" & "scuba diver": joint fault corrected

buckrogers opened this issue on Dec 13, 1999 · 2 posts
Back to Forum Print
buckrogers ( ) posted Mon, 13 December 1999 at 8:35 PM · edited Thu, 01 August 2024 at 5:10 PM
  • I have downloaded new versions of my "man in diving suit" and "scuba diver" which should cure the joint trouble that the previous versions had. - I am sorry for any nuisance caused. - Please pass this message on to all concerned.

Anthony Appleyard ( ) posted Tue, 14 December 1999 at 3:10 AM

The fault was that some time the geometry as described in his .OBJ file got displaced about 3 to 4 inches forwards and an inch or two down (to scale), leaving the CR2 file's stated joint positions where they were. I have corrected this by undoing that displacement, ans therefore I have also corrected the placing of his diving gear in scubadiver.pz3 to match.

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.