Forum Coordinators: RedPhantom
Poser - OFFICIAL F.A.Q (Last Updated: 2024 Oct 21 7:10 pm)
Hi Marque - yes, a while back I did see one at 3D Cafe but it was round like a barrell, and not quite what I was looking for. I got to tell you, that 'cuzi (as we call it) was one of the best investments we ever made. It's a wee bit expensive to run, cause we drain the water, clean it and refill it every 2 weeks, heat it, chemicals, etc. But we drained it last September and covered it... now the electric cops would be at our house in a minute if we even thought about heating it, and the water district would have a fit it we suddenly used 450 gallons of water. A health club would be cheaper, but ya gotta wear clothes LOL!
This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.
I've been trying to do this with Poser - I have Bryce, but have not learned it well enough. I have everything for the hot tub except the tub itself. I want to make 4 sides and a bottom - seems so easy. How do I group them together to make it one unit? I get confused by the perspective in trying to set it up. Like checking all views only to find nothing is lined up properly. At this point, I'd pay a small amount (i.e. $8-10) to anyone who could do this. Just a rectangle in redwood with molded seats that you can see beneath the water and the plastic looking rim around the box for arm rests and such. Just your typical above ground Jacuzzi (that I own but cannot use cause of water/electric prices and brownouts)... at least I could enjoy the model. Thanks in advance