Fri, Jan 31, 4:37 AM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2025 Jan 31 3:43 am)

Poser Gallery - Poser Freestuff

Subject: Half of object does not show up after import

Crescent opened this issue on Jul 15, 2001 ยท 5 posts
Back to Forum Print
Crescent ( ) posted Sun, 15 July 2001 at 2:41 PM ยท edited Fri, 31 January 2025 at 2:20 AM

I created a belt for Vicki in Rhino 2.0 but when I imported it (after UV Mapping it) only the back half shows. It renders just fine but it would be nice to see all of it when not rendered. I tried using the Grouping tool to flip individual polygons, but that did not help. Rhino shows the UVs facing the correct way. Any suggestions?

doozy ( ) posted Sun, 15 July 2001 at 3:32 PM

try checking "make normals consistent" when you import.

smerc ( ) posted Sun, 15 July 2001 at 4:10 PM

Attached Link: http://www.renderosity.com/messages.ez?Form.ShowMessage=343118

Check out reply #7 You need to check your normals before exporting to Poser. smerc

steveshanks ( ) posted Sun, 15 July 2001 at 4:15 PM

Do you have a back face culling switch in rhino?? i ge this all the time in cinema and switch BFC on to check them ..Steve

Xurge ( ) posted Sun, 15 July 2001 at 6:04 PM

file_191217.jpg

In Rhino before export, check the surface direction, if the arrows point inwards, type flip and hit enter. then make the mesh and export. This will correct the direction of the surface. The image highlights the direction arrows and the tool button for it.

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.