Sun, Sep 22, 3:43 AM CDT

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Sep 22 2:04 am)

Poser Gallery - Poser Freestuff

Subject: materials too big for Vic3

denden opened this issue on May 27, 2003 ยท 3 posts
Back to Forum Print
denden ( ) posted Tue, 27 May 2003 at 6:17 PM ยท edited Thu, 05 September 2024 at 3:49 AM

I can't figure out how to size material to map to Vic3. There isn't any info that I can find. Help, please. I'm trying to map a circuit board pattern to Vic3's face but the pattern is much to large. In trueSpace you select the number of times you wrap the texture. However, trueSpace doesn't like Vic3 and turns any texture into a solid color. Thanks for any suggestions.

ronstuff ( ) posted Tue, 27 May 2003 at 6:29 PM

Attached Link: http://www.uvmapper.com

If you are using Poser 5 you can do it by altering the scale of the material node, but if you are using Poser 4, you will have to create a new mesh object with revised UV mapping. You can use Steve Cox's UVMapper (see link) to do that, but you can't do it inside Poser 4.

denden ( ) posted Wed, 28 May 2003 at 11:46 AM

Thanks, ronstuff...I'm still with Poser 4 so I'll follow your suggestion and play with UVMapper. Thanks, again

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.