Sat, Feb 8, 11:31 AM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2025 Feb 08 9:27 am)

Poser Gallery - Poser Freestuff

Subject: When Conforming Clothes Meet

Lys1123 opened this issue on Jul 19, 2003 ยท 5 posts
Back to Forum Print
Lys1123 ( ) posted Sat, 19 July 2003 at 9:48 PM ยท edited Sat, 10 August 2024 at 8:07 AM

file_67845.jpg

I am trying to put a suit on Don. There is a conforming clothing set for a jacket and tie... and one for slacks. Either one alone works fine, but when I try to do both I get a jagged effect where they meet (see attached image).

I looked for conforming clothing in the Poser 5 manual, but only found where it said not to layer conforming clothing (on page 68) which doesn't help much.

So how can I fix this?

Thanks in advance
Sheridan

Crescent ( ) posted Sat, 19 July 2003 at 10:05 PM

You might be able to get it to fit by setting the "taper" dial by hand on the bottom of the jacket to a very low negative number. (Try -.2 or so on the hip, I believe.) I've had some luck with other figures using that method. Cheers!

nerd ( ) posted Sat, 19 July 2003 at 11:34 PM
Forum Moderator

Magnets... Select the hip of the coat. Object > Create Magnet. Select the horseshoe magnet prop. On the magnet properties box [select add element top deform] Pick the rButtock of the coat. Repeat for the lButtock and abdomen. Select the magnet zone and scale it to about 15%. Select the magnet and scale x and z to about 120%. You may need to adjust the placement of the zone and size a bit. Keep in mind too that the Business coat conforms nasty the joint setups are way wrong. Someday maybe I'll fix it and put up the improved CR2 as a freebie.

nerd ( ) posted Sat, 19 July 2003 at 11:50 PM
Forum Moderator

Wait wait wait... It looks like crap because the coat conforms so poorly. I reworked the coat conformer and it works much better keep an eye on the free stuff. I'll have it in there in a few minutes.

nerd ( ) posted Sun, 20 July 2003 at 12:52 AM
Forum Moderator

Check the Conforming FIgures department in the Free Stuff Nerd

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.