Mon, Dec 2, 2:02 PM CST

Renderosity Forums / Poser Technical

All Forums

Welcome to the Poser Technical Forum

Forum Moderators: Staff

Poser Technical F.A.Q (Last Updated: 2024 Nov 13 12:50 am)

Welcome to the Poser Technical Forum.

Where computer nerds can Pull out their slide rules and not get laughed at. Pocket protectors are not required. ;-)

This is the place you come to ask questions and share new ideas about using the internal file structure of Poser to push the program past it's normal limits.

New users are encouraged to read the FAQ sections here and on the Poser forum before asking questions.


Checkout the Renderosity MarketPlace - Your source for digital art content!

Subject: JCM's and sliders

DigiCalimero opened this issue on Dec 04, 2003 · 3 posts
Back to Forum Print
DigiCalimero ( ) posted Thu, 04 December 2003 at 10:04 PM · edited Mon, 02 December 2024 at 11:04 AM

When you have two joint controlled morphs for a body part, is it possible to have one of the morphs influence the geometry only if the joint moves in positive values, and the other morphs affect the geometry when the slider moves in negative values?

PhilC ( ) posted Fri, 05 December 2003 at 2:50 PM

Try this, set up two channels. In your positive channel set forceLimits to 4 and set your min to zero and your max to the required upper value. In your negative channel do the reverse.

philc_agatha_white_on_black.jpg

DigiCalimero ( ) posted Fri, 05 December 2003 at 3:02 PM

Ahaa, perfect! Thank you PhilC.

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.