Sat, Nov 23, 7:41 PM CST

Renderosity Forums / Carrara

All Forums

Welcome to the Carrara Forum

Forum Coordinators: Kalypso

Carrara F.A.Q (Last Updated: 2024 Nov 21 9:55 pm)

 

Visit the Carrara Gallery here.

Carrara Free Stuff here.

 
Visit the Renderosity MarketPlace - Your source for digital art content!
 

 

Subject: More on spline modeling

Kleinbaum opened this issue on Oct 16, 2000 · 1 posts
Back to Forum Print
Kleinbaum ( ) posted Mon, 16 October 2000 at 4:51 AM · edited Fri, 09 August 2024 at 8:49 PM

Greetings! Just started using Cararra and tried modelling a pump. I traced the lathe envelope and cross sections from the dimensional drawings in Illustrator and imported them as Illustrator 5.5 files into Carrara. Both Illustrator and Carrara were set for centimeters. The cross sections came in at the right scale, but the curves for the envelopes weren't right. On a hunch, I multiplied by 2.54 (conversion inches to cm) and they were bang on...well, give or take round off errors. Anyone else seen this? A feature? One shot deal, or something I have to remember? Thanks, Thomas Stump

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.