Sun, Nov 24, 4:52 AM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Nov 21 6:06 am)

Poser Gallery - Poser Freestuff

Subject: Tranferring Morph Targets between characters???

ericwestray opened this issue on Apr 07, 2001 ยท 5 posts
Back to Forum Print
ericwestray ( ) posted Sat, 07 April 2001 at 4:18 PM ยท edited Sat, 10 August 2024 at 6:24 AM

Is there a utility out there, or is there some way of transfering morph targets from one P4 character (millenium models included) to other like characters?

milamber42 ( ) posted Sat, 07 April 2001 at 4:28 PM

MorphManager. See this message. http://www.renderosity.com/messages.ez?Form.ShowMessage=266127

flamethedog ( ) posted Sat, 07 April 2001 at 4:41 PM

Set morph target dial to 1, all others to 0. Export as morph target. Load in other character that has same body part/vertice count.

Wizzard ( ) posted Sat, 07 April 2001 at 11:35 PM

Note.. the figures must use the same mesh geometry... i'e' newmalenudeHi.obj etc... other wise the MT will be there .. but not do anything... ye can't swap twixt ..say.. a P3 figure and the MilliMan Now magnets are another story.. those I think ye can swap.. though the MilliMan once again might be a bit difficult. Cheers poste scriptum, MOrphmanager should be in freestuff under utilities..

Gem_719 ( ) posted Sun, 08 April 2001 at 11:18 AM

Attached Link: http://www.3d-cc.com/3dhome.asp

Get MorphManager here: http://www.3d-cc.com/3dhome.asp It's on the home page under the 4/7/01 heading.

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.