Fri, Nov 15, 2:26 AM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Nov 14 4:48 pm)

Poser Gallery - Poser Freestuff

Subject: Poser 7 crash, won't load!!

Mhawke opened this issue on Jan 01, 2007 · 4 posts
Back to Forum Print
Mhawke ( ) posted Mon, 01 January 2007 at 11:15 PM · edited Sat, 10 August 2024 at 8:36 AM

Apologies if this situation has been covered before.

Installed Poser 7 about 10 days ago.
All was running fine, worked up several images,  till it apparently garbaged a .pz3 file.
Trying to open the file resulted in a windows error message that poser had caused a Windows fault and would close. After that the program would not even load without causing a crash.

Since then I have uninstalled and re-unstalled Poser7 4 times.
Even searched the windows registry and removed all reference to poser7 that I could find.
Tried installing in different directories and on different hard disk (same computer though).
Each time now it crashes on start-up, the program won't even load.

I still have Poser6 installed and it runs fine.
I also have Carrara, Hex, DAZStudio, Photoshop CS and several others and no problems.
Running diagnostics on my systems turns up no errors.
I have made no changes to my system or installed any additional programs since installing and running Poser7 10 days ago, all other programs run without problems.

I doubt the the installer files are corrupt as the program was originally installed from the same files and was running great prior to the (aparently) corrupted file issue.

I'm a IT guy and this one has me totally stumped.

Any advice appreciated.

nruddock ( ) posted Tue, 02 January 2007 at 12:11 AM

Did you remove the user preference files ?

These are no longer in the Poser directory tree, they've been moved to ":Documents and SettingsApplication DataPoser 7" and so wouldn't be removed by an uninstall.

Mhawke ( ) posted Tue, 02 January 2007 at 6:57 AM

DAMN!!!!!!!!!!!!!!!!

That was it. Thanks a million.

Apparently there was a corrupted ,pz3 file set to autoload, deleting that file and the .pmd, now the program starts properly.

Didn't realize (feel like a dummy now!) that settings were stored in that directory.

Thanks again.

nruddock ( ) posted Tue, 02 January 2007 at 10:38 AM

ReadMes are wonderful things 😉

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.