Thu, Dec 12, 9:44 AM CST

Renderosity Forums / Poser - OFFICIAL

All Forums

Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2024 Dec 12 3:30 am)

Poser Gallery - Poser Freestuff

Subject: Adding stuff to a Dynamic simulation

3doutlaw opened this issue on Dec 28, 2011 · 3 posts
Back to Forum Print
3doutlaw ( ) posted Wed, 28 December 2011 at 3:56 PM · edited Sun, 29 September 2024 at 6:49 AM

Not sure if that topic even makes sense to what I am trying to understand.

I am working with Dynamic cloth/outfits, and I start at frame 1, add them all, then go to frame 30 and pose the figure, and go to cloth room, run simulation after settings, etc.  All is good, good simulation, nice draping, pose, etc.

then i remember that I forgot hair, prop 2, etc...

So i go back to frame 1, add hair, parent it and roll back to frame 30...and it doesnt move with the figure.  I suppose that cause it ain't parented in every frame?  ...only in Frame 1?

So...the question is how can I setup something in Frame 1 so that it applies across all frames?  Thanks!

PhilC ( ) posted Wed, 28 December 2011 at 4:11 PM

Once set the parenting will be consistent.

Is the hair a prop or a figure? If a figure you may need to conform it to the base figure rather than parenting and/or pose the hair as required.

3doutlaw ( ) posted Wed, 28 December 2011 at 5:21 PM

Its an HR2, and it does not have a conforming option.  It just shows a parenting option.  I did make some scale and translate changes to the hair before parenting it, but I didn't think that would affect it (using Poser 9 sr1)

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.