Tue, Feb 4, 5:51 AM CST

Renderosity Forums / Poser - OFFICIAL



Welcome to the Poser - OFFICIAL Forum

Forum Coordinators: RedPhantom

Poser - OFFICIAL F.A.Q (Last Updated: 2025 Feb 03 12:46 am)



Subject: Poser 4 Window Problems


benz ( ) posted Sat, 01 December 2001 at 8:10 PM ยท edited Tue, 04 February 2025 at 5:48 AM

file_240092.JPG

I have Poser 4 Pro Pack, my resolution is 1024/768 when i open poser 4 my character window is in the upper left hand corner over my tools. i dont know how to move the window back to the center how it usually was. Please help.


Crakmine ( ) posted Sat, 01 December 2001 at 9:34 PM

yeah yeah, I've done this before too, heres what you do: Go to Edit-> General Preferences... then it should have 4 little buttons, over on the right, under interface preference, click the bubble for Launch to Factory State, then close out, and start it back up


Crakmine ( ) posted Sat, 01 December 2001 at 9:34 PM

eh, sry not Launch to factory state, but Use Factory State


benz ( ) posted Sat, 01 December 2001 at 9:39 PM

thanks


fmahr ( ) posted Sun, 02 December 2001 at 3:15 AM

Also try the Poser 2 interface switch. Type PO2 (the letters "P" and "O" and the number 2) on your keyboard, and to return to Poser 3 Type PO3. This puts the document window within reach, and you can pull it to the desired location. Also works in Poser 4.


DocMatter ( ) posted Sun, 02 December 2001 at 5:29 PM

You can also move just about anything in the window wherever you want by rightclicking on the title and dragging it around the page. If you then set that as your "preferred state" it should stay that way whenever you startup.


Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.