Hi, Can anyone suggest a 3d horse model that is Free or low cost. I've looked at the milhorse but don't want to spend too much as I'm only trying to experiment with modeling and poser in general. I've looked on turbosquid,zygote and of course DAZ.Just wondered if anyone else can suggest anywhere else?

Have you tried the DAZ Charger, relatively low cost and not too bad to use. There's a few images in my gallery with it if you want to have a look! thefixer, poser coord.

Attached Link: http://3dscience.com/free_3d_horse_model.asp

The 3dScience horse is the Poser 4 horse. Only not rigged for Poser. Not rigged at all, so you can't pose it. But if you want to learn to rig, check it out!

If you're using poser..you already should HAVE a horse ? And there are lots, and lots of freebies availible for it as well ?

Message edited on: 12/24/2005 00:09

Hi, Thanks for all the suggestions and comments. I'll try using the Poser 4 horse to start with a see how far I get. Thanks again.

At planit3d.com there are very nice morphs for the P4 horse!

At the site select '/Downloads/Poser/Injections & Morphs'.

so does zygote releaseing the mesh as a os mesh release the poser horse from (C) this is a little confusing ;~

No. The open source horse is only the solid mesh. Basically, it's a horse prop. You would have to group and rig it to make it posable. If you do that, you can distribute it, but you can't distribute the Poser version.