Sun, Nov 24, 10:09 AM CST

Renderosity Forums / Carrara

All Forums

Welcome to the Carrara Forum

Forum Coordinators: Kalypso

Carrara F.A.Q (Last Updated: 2024 Nov 21 9:55 pm)

 

Visit the Carrara Gallery here.

Carrara Free Stuff here.

 
Visit the Renderosity MarketPlace - Your source for digital art content!
 

 

Subject: Chamfer tool in Carrara 5 Pro

Plutom opened this issue on Apr 13, 2010 · 5 posts
Back to Forum Print
Plutom ( ) posted Tue, 13 April 2010 at 4:00 PM · edited Sat, 27 July 2024 at 12:28 AM

Hi gang, I've been going over the manual for Cararra 5 Pro and they mention the Chamfer tool and how to use it.  I can fillet all day long, no problem.  However, where is that chamfer tool or is fillet and chamfer the same thing, both round edges?  Jan 

MarkBremmer ( ) posted Tue, 13 April 2010 at 4:07 PM · edited Tue, 13 April 2010 at 4:08 PM

 It's the same as far as Carrara is concerned. Technically, a chamfer is a convex edge (rounded edge on a cube) and a fillet is a concave joint (like a plane wing joining the fuselage).

One of those unfortunate edits...





Plutom ( ) posted Tue, 13 April 2010 at 4:25 PM

Thanks Mark for your quick reply.  I sort of thought that since Carrara's definition of a chamfer read just like a fillet.  Jan

Xerxes0002 ( ) posted Tue, 13 April 2010 at 6:44 PM

Also a quick note in case you didn't see it you can get C6 pro in 3dArtist magazine.

Plutom ( ) posted Tue, 13 April 2010 at 7:02 PM

Sniffle, not if Books-a-Million doesn't sell the magazine (Barnes and Noble have left the office-closed up and moved).  Hopefully, 3DWorld Magazine will offer it some month.  Jan

Privacy Notice

This site uses cookies to deliver the best experience. Our own cookies make user accounts and other features possible. Third-party cookies are used to display relevant ads and to analyze how Renderosity is used. By using our site, you acknowledge that you have read and understood our Terms of Service, including our Cookie Policy and our Privacy Policy.