Ok so when i start the draping it begins to rotate my figure. Now i beleave in the scene before i had the sheet parented to my figures waist. Could that be the problem? If so how do i un parrent it to her waist? If not that what am i doing wrong lol

quick question:

did you move the camera when you applied the pose at whatever frame you applied it at?

bill

the first scene i did went great, then i re posed my figure for the next picture and did change the camera, so yes i guess =-)

That can happen.  I have gone all the way around at times and had animation spin.  but for your final render you repositon camaera every time so.....

Bill

"Animating" in your tab. In this case you can turn the camera, it will not affect the simulation.

This could help :)

At the bottom "Clear simulation" 

Quote - To avoid mess with the camera during simulation simply uncheck 

"Animating" in your tab. In this case you can turn the camera, it will not affect the simulation.

That is SO good to know! Thanks for that tip - going to uncheck some stuff, now... LOL

HUGS!~

Still no luck. I even deleated the sheet and created a new one. but when i place it over the V4 and set my sim up, once the sim begins V4 startes to rotate while the sheet falls towards her. What am i doing wrong here =-(

Take a look at this dress, it is parented to Antonia's chest and the small red line is the constrained group I made to hold this dress on her.

What is important to,avoid to turn V4 AFTER your final simulation pose.

Turn the camera with Animation OFF when you check for details.

Im doing all of this its just not working. I even deleatedthe sheet and made a new one. Im going to go deleate it again and try one last time here!

Try step by step

Load V4, Put your slider to a frame ( example15 ) Load the sheet, Parent the sheet to her waist ( or whatever)

Pose her, go to the cloth room 

Now put the upper line ( like you see on my example) as contrained group,

Set up your simulation setting values

Don't forget, Colide against V4 and REMOVE center of mass , now calculate simulation.

There is no reason why it should not work...:(

Could you please post some images with your scene and settings? Maybe this way we can find out what you did wrong :)

Remove center of mass? Where doo i do that at?

There you can add V4 and remove everything what is not needed.

Yup i do that!

How do i clear my frames, maybe thats why shes rotating. Cause when i move the frames it shows her rotating =-( I dont want any anamation, just her laying there and having the cloth fall onto her =-(

When you want to delete frames, click on the key from your animation slider

You got this pop up.

Worked =-) i deleated my key frames and bingo =-)  Thanks so much for helping out on this subjet =-)

Yuhuu :) Fantastic, glad I could help you :)